• FMC‐210‐DM Double Action Call Points

•  Adjustment after alarm triggering
•  Individual identification thanks to automatic or manual detector addressing
• Indicator LED for alarm or for inspection evaluation
•  Query routines with evaluation and multiple transmission
•  Maintains LSN loop functions in the event of wire interruption or short-circuit      thanks to two integrated isolators

The FMC-210-DM Double-action Call Points are used for manual triggering, and can be used in the Local SecurityNetwork LSN and LSN improved. Form H
Manual Call Points are designed for outdoor deployment, form G Manual Call Points are designed for indoor deployment.

In the event of an alarm, the glass pane (2) is broken first, then the manual call point (3) is pressed hard.This activates the microswitch for alarm triggering and the indicator LED (4) blinks. A mechanism holds the pressed call point down.

The manual call point can be reset with the reset lever (5) or by closing the door of the manual call point (1).The indicator LED (4) goes out.

This does not reset the alarm on the fire panel.

Individual call point identification with display of the call point address on the fire panel ensures the quick location of the triggered call point.

Variants

The designs of the manual call points for outdoor and indoor use are identical. The manual call points for indoor use (form G) are available in red, blue, yellow,and green. The manual call points for outdoor use (form H) are available in red and blue. Form H manual call points are equipped with an
especially resistant PC board layered with parylene.

Notice : The key must be ordered separately.

Improved LSN features
The manual call points offer all the features of the improved LSN technology:

• Flexible network structures, including T-tapping without additional elements

• Up to 254 LSN improved elements per loop or stub line

• Automatic or manual detector addressing selectable via rotary switch, in        each case with or without auto-detection

• Shielded and unshielded cables can be used

• Cable length up to 3000 m (with LSN 1500 Amodule)

• Downwards compatibility to existing LSN systems and control panels

Certifications and approvals

Installation/configuration notes

• The device must be mounted visibly along escape and rescue routes (e.g.      exits, passageways,stairwells) and be easily accessible.

• An installation height of 1400 mm ±200 mm,measured from the middle of    the device to the floor, must be maintained.

• The device must be adequately illuminated by sunlight or another light         source (including emergency lighting if present).

• The maximum number of LSN elements that may be connected depends on    their current consumption from the LSN data line. The limit values should be
  taken from the product information supplied with the fire panel used.

• Additional norms, guidelines, and planning recommendations with respect      to installation location, etc. must be taken into account (see fire detector       manual).

• The regulations of the local fire services must be observed.

Installation

• The cable duct can be surface-mounted or flush-mounted.

• Installation in fire hose cabinets is possible in three
ways:

1   ca. 40 mm
2   14 mm
3   min. 30 mm

Technical specifications